SHINGLE SPOILER OFF RIDGE VENT
Net Free Sq. Inch 101.5″
Cutout 2.75″ x 46.19″
Preparation
Minimum 4/12 pitch required. Cut out the off ridge opening in the roof sheathing as shown in Figure A. Size the opening in accordance with the correct cutting data models and locate the opening 6″ minimum off the peak of the roof as shown in Figure B. For single vent applications, install vent as close to the center of the roof length as possible. Install multiple vents in evenly spaced areas of the entire roof length. Do not cut into trusses or rafters when cutting hole in the roof.
Fitting
Vent placement with proper cut out to highest point of vent. Refer to most current approvals available online. Remove interfering shingle nails around the perimeter of the opening. Slide top and side flanges of the vent up and under shingles. Allow the bottom vent flanges to lay on top of shingles.
Mounting
Care should be taken in keeping the vent properly aligned. Nail in place using 1-1/4″ coating roofing nails spaced approximately 6″ – 12″ on center and1-1/2″ from each end. Roofing cement should be applied to all shingle edges and nail heads to prevent water leakage. In severe weather coastal construction zones, caulking around entire perimeter, under vent flanges and near outer edges is recommended.
Florida Building Approval Codes
Off Ridge Vent Baffle Evaluation/Certifications Report
Certified
Florida Building Code 11100.4
15 Standard Colors, Galvanized/Galvelume, 6 Premium Colors and Custom Colors Too!
All our standard colors meet energy star requirements.
Cool-Coat Chemistry Colors available in Standard and most Custom Colors.
Colors are an approximation.
Actual production colors may vary slightly from the samples on this website. To get a truer color please contact us for our printed Color Chart.
Thompson White*
Clay
Almond
Bone White
Grey
Grizzle Gray
Beige
Wicker
Light Stone**
Med Bronze
Marine Green
Forest Green
Country Red**
Brown
Musket Brown
Galvalume/Galvanized
All premium and custom coatings are subject to an additional cost.
All coated products available smooth or embossed finishing.
Colors are an approximation.
Actual production colors may vary slightly from the samples on this website. To get a truer color please contact us for our printed Color Chart.
* Meets Energy Star Requirements
Bronze* (metallic)
Copper Penny (metallic)
Patina Green
Cold Rolled Copper
Champagne* (metallic)
Terra Cotta
Need Help? Call Us at 800.248.3456
Or complete our response form to receive more information on our products and specifications.
TAMCO IS YOUR ONE-STOP FOR
METAL, ALUMINUM & VINYL ROOFING PRODUCTS
