TILE GOOSENECK VENT – SMALL
TILE GOOSENECK VENT – SMALL
One of the Only Florida Approved Goosenecks Available in the Industry
TAMCO Gooseneck Vents have been tested and approved by the State of Florida – FL#16918-R2.
Available Sizes
4″, 6″ and 10″
Shown in 4” Galvanized
Preparation
Cut out the Gooseneck Vent opening in the roof sheathing. Size the opening in accordance with the chart shown. In the event a mechanical vent fan is used, size the vent opening in accordance with vent fan manufacturer’s piping connection instructions.
Do not cut into trusses or rafters when cutting the opening in the roof.
Fitting
Remove interfering shingle nails around the perimeter of the opening so that the nailing flange of the vent lays flat to the roof sheathing. Slide the top and side flanges of the vent up and under shingles. Allow the bottom vent flanges to lay on the top of the shingles.
Mounting
Care should be taken in keeping the vent properly aligned. Vent pipe is sealed if utilized. Nail in place using 1-1/4″ nails at each corner. Roofing cement should be applied to all shingle edges near the outer edge and around the entire perimeter as recommended in severe weather coastal construction zones.
Florida Building Approval Codes
Gooseneck Vent Evaluation/Certification Report
Drawings
15 Standard Colors, Galvanized/Galvelume, 6 Premium Colors and Custom Colors Too!
All our standard colors meet energy star requirements.
Cool-Coat Chemistry Colors available in Standard and most Custom Colors.
Colors are an approximation.
Actual production colors may vary slightly from the samples on this website. To get a truer color please contact us for our printed Color Chart.
Thompson White*
Clay
Almond
Bone White
Grey
Grizzle Gray
Beige
Wicker
Light Stone**
Med Bronze
Marine Green
Forest Green
Country Red**
Brown
Musket Brown
Galvalume/Galvanized
All premium and custom coatings are subject to an additional cost.
All coated products available smooth or embossed finishing.
Colors are an approximation.
Actual production colors may vary slightly from the samples on this website. To get a truer color please contact us for our printed Color Chart.
* Meets Energy Star Requirements
Bronze* (metallic)
Copper Penny (metallic)
Patina Green
Cold Rolled Copper
Champagne* (metallic)
Terra Cotta
Need Help? Call Us at 800.248.3456
Or complete our response form to receive more information on our products and specifications.
TAMCO IS YOUR ONE-STOP FOR
METAL, ALUMINUM & VINYL ROOFING PRODUCTS
