DROP OUTLETS

Outlet tubes are the gutter fittings that attach the gutter to the downspout. A hole is cut out in the bottom of the gutter in the shape of the outlet tube that you are using. The outlet tube is then placed inside the gutter with the expanded flange keeping it from falling through the cut hole. The flange of the outlet is then riveted to the gutter. The downspout slips over the outlet tube to touch the bottom of the gutter and is fastened. Aluminum outlet tubes should be sealed with Ruscoe seam sealant.

Aluminum Mill Finish
Rectangle Drop Outlet – 3″ x  4″
Square Drop Outlet – 3″  x  3″

DOWNSPOUT BRACKET

Diamond Head Pipe Bands and Pipe Cleats are all individual parts used to fasten the downspout to the wall.

• Two (2) Diamond Head Pipe Bands are required for every 10 feet of downspout.
• Three (3) Diamond Head Pipe Bands are sufficient for a straight 20 foot run.
• For a 10 foot run, place (1) approximately 1 foot from the bottom and (1) one foot from the top.
• For a 20 foot run, place (1) approximately one foot from the bottom, (1) in the middle and (1) one foot from the top.

Packaged 100 pieces
6 colors matching Gutter colors

ALUMINUM GUTTER WEDGES

Wedges are used where fascia boards are not vertical, but slant back under. Wedges are a triangular piece of metal that hinge over the back of gutter and lays against the fascia board allowing the gutter to hang vertical.

100 per carton

OUTSIDE BOX MITER

Outside Box Miters are the corner pieces made up of two pieces of gutter that are seamed together. These are the contractor favorite because they look good and are fast and easy to install. Good for 90 degree corners. Outside Box miters should be riveted to the gutters and sealed with 12-1 Ruscoe Seam Sealant.

Available in aluminum, in both 5″ and 6″ sizes.
20 pieces per carton

6 colors matching Gutter colors

K STYLE OUTSIDE STRIP MITER

Outside Strip Miters require the two adjoining gutters to be cut on 45 degree angles. Strip miters are preferred by contractors who only want one seam per corner. Good for 90 degree corners. As with all miters, we recommend the seam to be pop riveted together and sealed with 12-1 Ruscoe seam sealer.

Available in aluminum in both 5″ and 6″.
20 pieces per carton

GUTTER SPIKES

Rain gutters are often held in place by a spike and ferrule: A giant nail is driven into the front of the gutter where it passes through an aluminum sleeve (the ferrule), through the rear of the gutter, and into the fascia and rafter end.

8″ Spikes available In White or Brown
500 per carton

POP RIVETS

At TAMCO we carry aluminum rivets. The mandrel part of the rivet measures at 7/16″ for the #44.

Colors available:
White, Bronze, Colonial Gray, Antique Ivory, Royal & Musket Brown

100 per pack – 1000 per box